Sonance Two Zone Connecting Block CB2Z Instrukcja Użytkownika Pobierz pdf

The Model CB2Z is a device that provides routing of infrared remote control signals. Independent

control of two audio/video systems can be obtained from two zones. One emitter port is provided

for each zone, plus one common port so that certain components can be controlled from both zones.

The CB2Z is a simplified unit, intended for use when only two zones are needed.

INSTALLATION INSTRUCTIONS

CB2Z

TWO ZONE CONNECTING BLOCK

Fig. 1: CB2Z Two Zone Connecting Block

Mounted in 3” SNAPTRACK

(SNAPTRACK is a registered trademark of AUGAT)

SPECIFICATIONS

• Inputs: 2 - Four screw removable

connectors to interface with all

3-wire IR receivers (see Caution

Note, Fig. 2, below)

• Outputs:Two zone emitter ports and 1

common emitter port (3.5mm

miniature phone jacks).

• Can be used with a CB1 Connecting Block or

an ACB1 Amplified Connecting Block for

COMMON emitter expansion. (See Fig. 4 & 5)

• Uses Sonance E1, VE1, E2 and VE2 Mini Emitters.

• Power requirements: 12 volts DC. Uses PS1

or PS2 Power Supplies.

• 2.1 mm coaxial power jack.

• Dimensions: 2-3/8"W x 3"D x 13/16" H.

CAUTION: For Shielded Wire and Long Lead Lengths

When using lengths greater than 200 feet of inter-room shielded cable, it may be

necessary to connect a 470 Ohm 1/8 Watt resistor between I N P U T (SIG) and

GROUND (GND) at the IR input terminals of the CB2Z. Refer to Fig. 2, above. The

resistor discharges the cable capacitance more quickly, allowing IR codes of high bit

Fig. 2: 470 Ohm Capacitance

Discharge Resistor

1 2 3 4

Podsumowanie treści

Strona 1 - TWO ZONE CONNECTING BLOCK

The Model CB2Z is a device that provides routing of infrared remote control signals. Independentcontrol of two audio/video systems can be obtained fro

Strona 2 - Fig. 3: A Typical Two-Zone

PgFig. 3: A Typical Two-ZoneNOTE: For clarity,connections to the 3-conductor cables in thisillustration are shown in"daisy chain" fashion.

Strona 3

Pg 3Power Supply Requirement:1. Most IR receivers draw 2 milliamps (mA) without signal and 10 mA with signal (check specs. onactual model).2. The maxi

Strona 4 - 33-1891 4.02

Komentarze do niniejszej Instrukcji

Brak uwag

Sonance Two Zone Connecting Block CB2Z Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Sprzęt komputerowy Sonance Two Zone Connecting Block CB2Z. Sonance Two Zone Connecting Block CB2Z User Manual Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji